Idrac Settings Utility; Device Settings - Dell EMC NX430 System Owner's Manual

Option Description
F1/F2 Prompt on Enables or disables the F1/F2 prompt on error. This option is set to Enabled by default. The F1/F2 prompt also
Error includes keyboard errors.
Load Legacy Video N/A
Option ROM
Dell Wyse P25/P45 Enables or disables the Dell Wyse P25/P45 BIOS Access. This option is set to Enabled by default.
BIOS Access
Power Cycle Enables or disables the Power Cycle Request. This option is set to None by default.
Request

iDRAC Settings utility

The iDRAC settings utility is an interface to set up and configure the iDRAC parameters. You can enable or disable various iDRAC
parameters by using the iDRAC settings utility available with iDRAC Enterprise License.
NOTE: The NX Series systems support only BIOS mode. Do not change the boot mode to UEFI because the system will not load
the appliance OS when in UEFI mode.
For more information about using iDRAC, see Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals.
Entering the iDRAC Settings utility
1 Turn on or restart the managed system.
2 Press F2 during Power-on Self-test (POST).
3 On the System Setup Main Menu page, click iDRAC Settings.
The iDRAC Settings screen is displayed.
Changing the thermal settings
The iDRAC settings utility enables you to select and customize the thermal control settings for your system.
1 Click iDRAC Settings > Thermal.
2 Under SYSTEM THERMAL PROFILE > Thermal Profile, select one of the following options:
• Default Thermal Profile Settings
• Maximum Performance (Performance Optimized)
• Minimum Power (Performance per Watt Optimized)
3 Under USER COOLING OPTIONS, set the Fan Speed Offset, Minimum Fan Speed, and Custom Minimum Fan Speed.
4 Click Back > Finish > Yes.

Device Settings

Device Settings enables you to configure device parameters.
Pre-operating system management applications 41