Installing An Expansion Card - Dell EMC NX430 System Owner's Manual

Figure 22. Removing and installing the expansion card from the expansion card riser
1 touch point (2)
3 expansion card riser
Next steps
1 Install the filler bracket or expansion card, if applicable.
2 Install the expansion card riser
3 Follow the procedure listed in the After working inside your system section.

Installing an expansion card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Remove the expansion card riser.
4 If installed, remove the filler bracket.
Steps
1 Locate the expansion card connector on the riser.
2 Holding the expansion card by its edges, position the card so that the card connector aligns with the connector on the expansion card
riser.
3 Insert the card connector into the expansion card riser connector until the card is firmly seated.
4 If required, connect the cables to the expansion card.
Next steps
1 Install the expansion card riser.
2 Follow the procedure listed in the After working inside your system section.
2 expansion card riser connector
4 expansion card
Installing and removing system components 71