Table of Contents
Advertisement
Steps
1
Try using a different CD or DVD.
2
If the problem is not resolved, enter System Setup and ensure that the integrated SATA controller and the drive's SATA port are
enabled.
3
Run the appropriate diagnostic test.
4
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
5
If installed, remove the bezel.
6
Remove the system cover.
7
Ensure that the interface cable is securely connected to the optical drive and to the controller.
8
Ensure that a power cable is properly connected to the drive.
9
Install the system cover.
Next step
If the problem persists, see the Getting help section.
Troubleshooting a tape backup unit
Prerequisite
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
1
Use a different tape cartridge.
2
Ensure that the device drivers for the tape backup unit are installed and are configured correctly. See your tape drive documentation
for more information about device drivers.
3
Reinstall the tape-backup software as instructed in the tape-backup software documentation.
4
Ensure that the interface cable of the tape drive is connected to the external port on the controller card.
5
Perform the following steps to ensure that the controller card is properly installed:
a
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
b Remove the system cover.
c
Reseat the controller card in the expansion card slot.
d Install the system cover.
e
Turn on the system and attached peripherals.
6
Run the appropriate diagnostic test. For more information, see the Using system diagnostics.
Next step
If you cannot resolve the problem, see the Getting help section.
Troubleshooting a hard drive
Prerequisites
CAUTION:
This troubleshooting procedure can erase data stored on the hard drive. Before you proceed, back up all files on the
hard drive.
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
1
Run the appropriate diagnostic test. See the Using system diagnostics section.
Troubleshooting your system
111
Advertisement
Table of Contents
Troubleshooting
