Removing The Expansion Card Riser - Dell EMC NX430 System Owner's Manual

Removing the expansion card riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
Steps
1 Lift and rotate the expansion card riser latch to open it.
2 Holding the touch points, lift the expansion card riser from the riser connector on the system board.
Figure 21. Removing and installing the expansion card riser
1 expansion card riser
3 expansion card latch
5 riser connector on the system board
7 guide slot on the expansion card riser
Next step
Install the expansion card riser.
2 touch point (2)
4 guide slot on the chassis
6 guide pin on the system board
Installing and removing system components 69