Dell EMC NX430 System Owner's Manual page 37

Option Description
Port F
For AHCI or RAID mode, BIOS support is always enabled.
Option
Model
Drive Type
Capacity
Integrated Devices
You can use the Integrated Devices screen to view and configure the settings of all integrated devices including the video controller,
integrated RAID controller, and the USB ports.
Viewing Integrated Devices
To view the Integrated Devices screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click Integrated Devices.
Integrated Devices details
The Integrated Devices screen details are explained as follows:
Option Description
User Accessible Enables or disables the USB ports. Selecting Only Back Ports On disables the front USB ports, selecting All Ports
USB Ports Off disables all USB ports. The USB keyboard and mouse operate during boot process in certain operating systems.
After the boot process is complete, the USB keyboard and mouse do not work if the ports are disabled.
Internal USB Port Enables or disables the internal USB port. This option is set to Enabled by default.
Integrated Network Enables or disables the integrated network card.
Card 1
Embedded NIC1
and NIC2
Enables or disables the Embedded NIC1 and NIC2 options. If set to Disabled, the NIC may still be available for
shared network access by the embedded management controller. The embedded NIC1 and NIC2 options are only
available on systems that do not have Network Daughter Cards (NDCs). The Embedded NIC1 and NIC2 option is
mutually exclusive with the Integrated Network Card 1 option. Configure the Embedded NIC1 and NIC2 option by
using the NIC management utilities of the system.
Embedded Video Enables or disables the Embedded Video Controller option. This option is set to Enabled by default.
Controller
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Specifies the total capacity of the hard drive. This field is undefined for removable media
devices such as optical drives.
NOTE: Selecting Only Back Ports On and All Ports Off disables the USB management port and also
restricts access to iDRAC features.
NOTE: The Embedded NIC1 and NIC2 options are only available on systems that do not have Integrated
Network Card 1.
Pre-operating system management applications 37