Boss JamStation JS-5 Owner's Manual page 97

FEEDBACK -98–+98%
Specify the proportion (%) of the flanger sound that is to be
returned to the input.
Positive (+) settings will return the signal to the input with
the original phase, while negative (-) settings produce an
inverted phase.
Higher settings will produce a more distinctive sound.
PHASE 0–180
Specify the spaciousness of the flanger sound.
STEP RATE
0.05–10.0 Hz/ / / / / / / / / /
Specify the frequency of pitch change.
* When set with a note, the Step Rate is synchronized to the
MIDI clock of the JS-5 or an external device. Use Clock
Source (p. 133), a system parameter, to select whether the
MIDI clock of the JS-5 or the external device is to be used for
synchronization.
* When a numerical setting is made, the MIDI clock is ignored.
If the setting is made with a note but no external MIDI clock is
received, the changes in pitch are synchronized with the JS-5's
built-in default tempo (p. 133).
LOW GAIN -15–+15 dB
Specify the gain (amount of boost or cut) for the low
frequency range.
Positive (+) settings will emphasize (boost) the low
frequency range.
HI GAIN (High Gain) -15–+15 dB
Specify the gain (amount of boost or cut) for the high
frequency range.
Positive (+) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect Balance) D100:0E–D0:100E
Specify the volume balance between the original sound and
the flanger sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:100E only the flanger sound
will be output.
LEVEL (Output Level) 0–127
Specify the output volume.
Chapter 7 Changing Effect Settings
STEREO-DLY (Stereo Delay)
This is a stereo delay.
When FB MODE parameter is NORMAL:
fig.RE07-117a
Balance D
L in
Delay
Feedback
Feedback
Delay
R in
Balance D
When FB MODE parameter is CROSS:
fig.RE07-117b
Balance D
L in
Delay
Feedback
Feedback
Delay
R in
Balance D
DELAY L (Delay Time Left) 0.0–500 ms
Specify the delay time from the original sound until the left
delay sound is heard.
DELAY R (Delay Time Right) 0.0–500 ms
Specify the delay time from the original sound until the right
delay sound is heard.
FEEDBACK -98–+98%
Specify the proportion (%) of the delay sound that is to be
returned to the input.
Positive (+) settings will return the sound to the input with
the original phase, while negative (-) settings produce an
inverted phase.
FB MODE (Feedback Mode) NORMAL/CROSS
Specify the input destination to which the delay sound will
be returned.
NORMAL:
The left delay sound will be returned to the left input, and
the right delay sound to the right input.
CROSS:
The left delay sound will be returned to the right input, and
the right delay sound to the left input.
2-Band
L out
EQ
Balance E
Balance E
2-Band
R out
EQ
2-Band
L out
EQ
Balance E
Balance E
2-Band
R out
EQ
97