Boss JamStation JS-5 Owner's Manual page 90

Chapter 7 Changing Effect Settings
STEREO-EQ (Stereo Equalizer)
This is a stereo equalizer which allows you to adjust the tone quality
using a low range, two mid-range, and a high range control.
fig.RE07-101
L in
4-Band EQ
R in
4-Band EQ
LOW FREQ (Low Frequency) 200/400 Hz
Select the frequency at which the low frequency range will be
adjusted.
LOW GAIN -15–+15 dB
Specify the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low range.
HI FREQ (High Frequency) 4000/8000 Hz
Select the frequency at which the high range will be adjusted.
HI GAIN (High Gain) -15–+15 dB
Specify the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high range.
P1 FREQ (Peaking 1 Frequency) 200–8000 Hz
Specify the center frequency of the region in which the boost
or cut will take place.
P1 Q (Peaking 1 Q) 0.5/1.0/2.0/4.0/8.0
Specify the width of the region centered on the P1 FREQ
setting.
Higher settings will cause the region affected by P1 GAIN to
be narrower.
P1 GAIN (Peaking 1 Gain) -15–+15 dB
Specify the gain (amount of boost or cut) that will take place
in the region specified by P1 FREQ and P1 Q.
Positive (+) settings will emphasize (boost) the region
specified by P1 FREQ and P1Q.
P2 FREQ (Peaking 2 Frequency) 200–8000 Hz
Specify the center frequency of the region in which the boost
or cut will take place.
P2 Q (Peaking 2 Q) 0.5/1.0/2.0/4.0/8.0
Specify the width of the region centered on the P2 FREQ setting.
Higher settings will cause the region affected by P2 GAIN to
be narrower.
90
P2 GAIN (Peaking 2 Gain) -15–+15 dB
Specify the gain (amount of boost or cut) that will take place
in the region specified by P2 FREQ and P2 Q.
Positive (+) settings will emphasize (boost) the region
specified by P2 FREQ and P2Q.
L out
LEVEL (Output Level) 0–127
R out
Specify the output volume.
OVERDRIVE
Overdrive produces a natural-sounding distortion similar to
that produced by a vacuum tube amplifier.
fig.RE07-102
L in
R in
DRIVE 0–127
Specify the depth of distortion. The volume will change
together with the depth of distortion.
LEVEL (Output Level) 0–127
Specify the output volume.
You can use the Output Level setting to even out the volume
difference between the sound with and without Overdrive.
LOW GAIN -15–+15 dB
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
HI GAIN (High Gain) -15–+15 dB
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
AMP (Amp Type)
SMALL/BUILT-IN/2-STACK/3-STACK
Select the type of guitar amp.
SMALL:
BUILT-IN:
2-STACK:
3-STACK:
Over Amp 2-Band
drive Simulator EQ
This simulates a compact amp.
This simulates a built-in amp.
This simulates a large two-stack amp.
This simulates a large three-stack amp.
L out
R out