Boss JamStation JS-5 Owner's Manual page 93

LOW SLOW (Low Frequency Slow Rate) 0.05–10.0 Hz
Specify the low-speed (SLOW) rotational speed of the low-
range rotor.
LOW FAST (Low Frequency Fast Rate) 0.05–10.0 Hz
Specify the high-speed (FAST) rotational speed of the low-
range rotor.
LOW ACCL (Low Frequency Acceleration) 0–15
Specify the time required for the rotational speed of the low-
range rotor to change from the low speed to the high speed
(or from the high speed to the low speed). More time will be
required as the value of this parameter is decreased.
LOW LEVEL (Low Frequency Level) 0–127
Specify the volume of the low-range rotor.
HI SLOW (High Frequency Slow Rate) 0.05–10.0 Hz
Specify the low-speed (SLOW) rotational speed of the high-
range rotor.
HI FAST (High Frequency Fast Rate) 0.05–10.0 Hz
Specify the high-speed (FAST) rotational speed of the high-
range rotor.
HI ACCL (High Frequency Acceleration) 0–15
Specify the time required for the rotational speed of the high-
range rotor to change from the low speed to the high speed
(or from the high speed to the low speed). More time will be
required as the value of this parameter is decreased.
HI LEVEL (High Frequency Level) 0–127
Specify the volume of the high-range rotor.
SEPARATE 0–127
Specify the spaciousness of the sound.
SPEED SLOW/FAST
Select the rotational speed of the low-range rotor and high-
range rotor.
SLOW:
The specified rotational speeds (the LOW SLOW RATE/HI
SLOW RATE values) will take effect.
FAST:
The specified rotational speeds (the LOW FAST RATE/HI
FAST RATE values) will take effect.
LEVEL (Output Level) 0–127
Specify the output volume.
Chapter 7 Changing Effect Settings
COMPRESSOR
Compressor is an effect which restricts high sound levels and
boosts low sound levels, thus smoothing out variations in
volume.
fig.RE07-109
L in
Compressor
R in
ATTACK (Attack Time) 0–127
Specify the attack time of the input sound.
SUSTAIN (Sustain Level) 0–127
Specify the time over which low-level sounds are boosted to
a constant volume level.
POST GAIN 0/+6/+12/+18
Specify the output level.
LOW GAIN -15–+15 dB
Specify the low frequency range gain (amount of boost or
cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
HI GAIN (High Gain) -15–+15 dB
Specify the high frequency range gain (amount of boost or
cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
LEVEL (Output Level) 0–127
Specify the output volume.
LIMITER
Limiter is an effect which compresses sounds that are louder
than a specified volume level, preventing distortion from
occurring.
fig.RE07-110
L in
Limiter
R in
THRESHOLD (Threshold Level) 0–127
Specify the volume level at which compression will begin.
RATIO (Compression Ratio) 1.5:1/2:1/4:1/100:1
Specify the compression ratio.
RELEASE (Release Time) 0–127
Specify the time from when the volume falls below the
threshold level until the limiter effect no longer applies.
L out
2-Band
EQ
R out
L out
2-Band
EQ
R out
93