Boss JamStation JS-5 Owner's Manual page 106

Chapter 7 Changing Effect Settings
CHO BAL (Chorus Balance) D100:0E–D0:100E
Specify the volume balance between the enhancer sound that
does not pass through the chorus and the enhancer sound
that does pass through the chorus.
A setting of D100:0E will output only the enhancer sound,
and a setting of D0:100E will output only the enhancer sound
that is passed through the chorus.
LEVEL (Output Level) 0–127
Specify the output volume.
EH FL (Enhancer
This effect connects an enhancer and a flanger in series.
fig.RE07-133
L in
Enhancer
Mix
R in Enhancer
Mix
EH SENS (Enhancer Sensitivity) 0–127
Specify the sensitivity of the enhancer.
EH MIX (Enhancer Mix Level) 0–127
Specify the volume of the overtones generated by the
enhancer, relative to the original sound.
FL PRE DLY (Flanger Pre delay) 0.0–100 ms
Specify the time delay from the original sound until the
flanger sound is heard.
FL RATE (Flanger Rate) 0.05–10.0 Hz
Specify the modulation frequency of the flanger sound.
FL DEPTH (Flanger Depth) 0–127
Specify the modulation depth of the flanger sound.
FL FEEDBACK (Flanger Feedback) -98–+98%
Specify the proportion (%) of the flanger sound which will be
returned to the input. Positive (+) settings will return the
sound to the input with the original phase, while negative (-)
settings produce an inverted phase.
FL BAL (Flanger Balance) D100:0E–D0:100E
Specify the volume balance between the enhancer sound that
does not pass through the flanger and the enhancer sound
that does pass through the flanger.
A setting of D100:0E will output only the enhancer sound,
and a setting of D0:100E will output only the enhancer sound
that is passed through the flanger.
LEVEL (Output Level) 0–127
Specify the output volume.
106
Flanger)
Balance D
L out
Feedback
Balance E
Flanger
Balance E
R out
Balance D
EH DLY (Enhancer
This effect connects an enhancer and delay in series.
fig.RE07-134
L in
Enhancer
Mix
R in Enhancer
Mix
EH SENS (Enhancer Sensitivity) 0–127
Specify the sensitivity of the enhancer.
EH MIX (Enhancer Mix Level) 0–127
Specify the volume of the overtones generated by the
enhancer, relative to the original sound.
DLY TIME (Delay Time) 0.0–500 ms
Specify the time delay from the original sound until the delay
sound is heard.
DLY FB (Delay Feedback) -98–+98%
Specify the proportion (%) of the delay sound that is to be
returned to the input.
Positive (+) settings will return the sound to the input with
the original phase, while negative (-) settings produce an
inverted phase.
DLY HF (Delay HF Damp) 200–8000 Hz, BYPASS
Specify the frequency at which the high frequency range of
the delayed sound returned to the input will be cut.
If you do not want the sound to be cut, select BYPASS.
DLY BAL (Delay Balance) D100:0E–D0:100E
Specify the volume balance between the enhancer sound that
does not pass through the delay and the enhancer sound that
does pass through the delay.
A setting of D100:0E will output only the enhancer sound,
and a setting of D0:100E will output only the enhancer sound
that is passed through the delay.
LEVEL (Output Level) 0–127
Specify the output volume.
Delay)
L out
Balance D
Balance E
Delay
Balance E
Feedback
R out
Balance D