Boss JamStation JS-5 Owner's Manual page 96

Chapter 7 Changing Effect Settings
BALANCE (Effect Balance) D100:0E–D0:100E
Specify the volume balance between the original sound and
the chorus sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:100E only the chorus sound
will be output.
LEVEL (Output Level) 0–127
Specify the output volume.
STEREO-FL (Stereo Flanger)
This is a stereo flanger (the LFO has the same phase for left
and right). This produces a metallic resonance reminiscent of
a jet airplane taking off and landing. A filter is provided so
that you can adjust the tone of the flanger sound.
fig.RE07-115
Balance D
L in
Flanger
Feedback
Feedback
Flanger
R in
Balance D
PRE DELAY (Pre Delay Time) 0.0–100 ms
Specify the time delay from the original sound until the
flanger sound is heard.
RATE (LFO Rate) 0.05–10.0 Hz
Specify the modulation frequency of the flanger sound.
DEPTH (LFO Depth) 0–127
Specify the modulation depth of the flanger sound.
FFEDBACK -98–+98%
Specify the proportion (%) of the flanger sound that is to be
returned to the input.
Positive (+) settings will return the signal to the input with
the original phase, while negative (-) settings produce an
inverted phase.
Higher settings will produce a more distinctive sound.
PHASE 0–180
Specify the spaciousness of the flanger sound.
FILTER TYPE OFF/LPF/HPF
Specify the type of filter.
OFF:
A filter will not be used.
LPF (Low-pass Filter):
Cut the frequency region above the Cutoff Freq setting.
96
2-Band
L out
EQ
Balance E
Balance E
2-Band
R out
EQ
HPF (High-pass Filter):
Cut the frequency region below the Cutoff Freq setting.
CUTOFF (Cutoff Frequency) 200–8000 Hz
Specify the frequency at which the filter will begin cutting.
LOW GAIN -15–+15 dB
Specify the gain (amount of boost or cut) for the low
frequency range.
Positive (+) settings will emphasize (boost) the low
frequency range.
HI GAIN (High Gain) -15–+15 dB
Specify the gain (amount of boost or cut) for the high
frequency range.
Positive (+) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect Balance) D100:0E–D0:100E
Specify the volume balance between the original sound and
the flanger sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:100E only the flanger sound
will be output.
LEVEL (Output Level) 0–127
Specify the output volume.
STEP-FL (Step Flanger)
Step flanger is a flanger in which the pitch of the flanger
sound changes in steps. The frequency of the pitch change
can be specified as a note length of a specific tempo.
fig.RE07-116
Balance D
L in
Step Flanger
Feedback
Feedback
Step Flanger
R in
Balance D
PRE DELAY (Pre Delay Time) 0.0–100 ms
Specify the time delay from the original sound until the
flanger sound is heard.
RATE (LFO Rate) 0.05–10.0 Hz
Specify the modulation frequency of the flanger sound.
DEPTH (LFO Depth) 0–127
Specify the modulation depth of the flanger sound.
2-Band
L out
EQ
Balance E
Balance E
2-Band
R out
EQ