Boss JamStation JS-5 Owner's Manual page 95

You can use the Tremolo Chorus as an Auto Pan by using the
following settings for the Tremolo Chorus.
PRE DELAY: 0 ms
CHO DEPTH: 0
TREM PHASE: 180
TREM DEPTH: 127
BALANCE: D0:100E
SPACE-D
Space-D is a multiple chorus that applies two-stage
modulation in stereo. Provides a truly lucent chorus sound.
fig.RE07-113
Balance D
L in
Space D
Space D
R in
Balance D
PRE DELAY (Pre Delay Time) 0.0–100 ms
Specify the delay time from the original sound until the
chorus sound is heard.
RATE (Chorus Rate) 0.05–10.0 Hz
Specify the modulation frequency of the chorus sound.
DEPTH (Chorus Depth) 0–127
Specify the modulation depth of the chorus sound.
PHASE 0–180
Specify the spaciousness of the chorus sound.
LOW GAIN -15–+15 dB
Specify the gain (amount of boost or cut) for the low
frequency range. Positive (+) settings will emphasize (boost)
the low frequency range.
HI GAIN (High Gain) -15–+15 dB
Specify the gain (amount of boost or cut) for the high
frequency range. Positive (+) settings will emphasize (boost)
the high frequency range.
BALANCE (Effect Balance) D100:0E–D0:100E
Specify the volume balance between the original sound and
the chorus sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:100E only the chorus sound
will be output.
2-Band
L out
EQ
Balance E
Balance E
2-Band
R out
EQ
Chapter 7 Changing Effect Settings
LEVEL (Output Level) 0–127
Specify the output volume.
STEREO-CHO (Stereo Chorus)
This is a stereo chorus. A filter allows you to adjust the tone
of the chorus sound.
fig.RE07-114
Balance D
L in
Chorus
Chorus
R in
Balance D
PRE DELAY (Pre Delay Time) 0.0–100 ms
Specify the time delay from the original sound until the
chorus sound is heard.
RATE (Chorus Rate) 0.05–10.0 Hz
Specify the modulation frequency of the chorus sound.
DEPTH (Chorus Depth) 0–127
Specify the modulation depth of the chorus sound.
PHASE 0–180
Specify the spaciousness of the chorus sound.
FILTER TYPE OFF/LPF/HPF
Select the type of filter.
OFF:
A filter will not be used.
LPF (Low-pass Filter):
The frequency region above the Cutoff Freq setting will be
cut.
HPF (High-pass Filter):
The frequency region below the Cutoff Freq setting will be
cut.
CUTOFF (Cutoff Frequency) 200–8000 Hz
Specify the frequency at which the filter will begin cutting.
LOW GAIN -15–+15 dB
Specify the gain (amount of boost or cut) for the low
frequency range. Positive (+) settings will emphasize (boost)
the low frequency range.
HI GAIN (High Gain) -15–+15 dB
Specify the gain (amount of boost or cut) for the high
frequency range. Positive (+) settings will emphasize (boost)
the high frequency range.
2-Band
L out
EQ
Balance E
Balance E
2-Band
R out
EQ
95