Boss JamStation JS-5 Owner's Manual page 103

LOW GAIN -15–+15 dB
Specify the gain (amount of boost or cut) of the low
frequency range. Positive (+) settings will emphasize (boost)
the low frequency range.
HI GAIN (High Gain) -15–+15 dB
Specify the gain (amount of boost or cut) of the high
frequency range.
Positive (+) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect Balance) D100:0E–D0:100E
Specify the volume balance between the original sound and
the reverb sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:100E only the reverb sound
will be output.
LEVEL (Output Level) 0–127
Specify the output volume.
GATE-REVERB
Gate reverb is a type of reverb effect which cuts the reverb
sound during its decay.
fig.RE07-125
L in
Balance D
Gate Reverb
R in
Balance D
TYPE (Reverb Type)
NORMAL/REVERSE/ SWEEP1/SWEEP2
Specify the type of reverb.
NORMAL: Conventional gated reverb.
Reverse reverb.
REVERSE:
SWEEP1: The reverb sound moves from right to left.
SWEEP2: The reverb sound moves from left to right.
PRE DELAY (Pre Delay Time) 0.0–100 ms
Specify the time delay from the original sound until the
reverb is heard.
GATE TIME 5–500
Specify the length of the reverb sound.
LOW GAIN -15–+15 dB
Specify the gain (amount of boost or cut) of the low
frequency range.
Positive (+) settings will emphasize (boost) the low
frequency range.
2-Band
L out
EQ
Balance E
Balance E
2-Band
R out
EQ
Chapter 7 Changing Effect Settings
HI GAIN (High Gain) -15–+15 dB
Specify the gain (amount of boost or cut) of the high
frequency range.
Positive (+) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect Balance) D100:0E–D0:100E
Specify the volume balance between the original sound and
the reverb sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:100E only the reverb sound
will be output.
LEVEL (Output Level) 0–127
Specify the output volume.
OD CHO (Overdrive
This effect connects an overdrive and chorus in series.
fig.RE07-126
L in
Overdrive
R in
OD DRIVE 0–127
Specify the amount of distortion for the overdrive. The
volume will change together with the amount of distortion.
CHO PREDLY (Chorus Pre delay) 0.0–100 ms
This sets the interval from the time when the original sound
is played until the time when the chorus sound is played.
CHO RATE (Chorus Rate) 0.05–10.0 Hz
Specify the modulation frequency of the chorus sound.
CHO DEPTH (Chorus Depth) 0–127
Specify the modulation depth of the chorus sound.
CHO BAL (Chorus Balance) D100:0E–D0:100E
Specify the relative volume levels for the overdrive sound
that does not pass through chorus, versus that which does.
A setting of D100:0E will result in output of solely the
overdrive sound, while a setting of D0:100E will cause only
the overdrive sound that is passed through chorus to be
output.
LEVEL (Output Level) 0–127
Specify the output volume.
Chorus)
L out
Balance D
Balance E
Chorus
Balance E
R out
Balance D
103