Boss JamStation JS-5 Owner's Manual page 91

DISTORTION
Distortion produces a more intense distortion than the
Overdrive effect.
fig.RE07-103
L in
Amp
Distortion
Simulator
R in
DRIVE 0–127
Adjust the amount of distortion. The volume will change
together with the amount of distortion.
LEVEL (Output Level) 0–127
Specify the output volume.
You can use the Output Level setting to even out the volume
difference between the sound with and without Distortion.
LOW GAIN -15–+15 dB
Specify the low range gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
HI GAIN (High Gain) -15–+15 dB
Specify the high range gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
AMP (Amp Type)
SMALL/BUILT-IN/2-STACK/3-STACK
Specify the type of guitar amp.
SMALL: This simulates a compact amp.
BUILT-IN: This simulates a built-in amp.
This simulates a large two-stack amp.
2-STACK:
This simulates a large three-stack amp.
3-STACK:
L out
2-Band
EQ
R out
Chapter 7 Changing Effect Settings
PHASER
Phaser is an effect that adds a phase-shifted sound to the
original sound to create time-varying change, modulating
the sound.
fig.RE07-104
L in
Phaser
R in
Resonance
MANUAL 100 Hz–8 kHz
Specify the center frequency at which the sound is
modulated.
RATE (Phaser Rate) 0.05–10.0 Hz
Specify the frequency of modulation.
DEPTH (Phaser Depth) 0–127
Specify the depth of modulation.
RESONANCE 0–127
Specify the amount of feedback for the phaser. Higher
settings will give the sound a stronger character.
MIX (Mix Level) 0–127
Specify the volume of the phase-shifted sound, relative to the
direct sound.
LEVEL (Output Level) 0–127
Specify the output volume.
SPECTRUM
Spectrum is a type of filter which boosts or cuts the level at
specific frequencies to modify the tone.
It functions similarly to the equalizer, but since the eight
frequencies are fixed at positions ideal for giving the sound
more character, more distinctive sounds can be created.
fig.RE07-105
L in
Spectrum
R in
The sounds are set with BANDs 1 to 6.
BAND 1 (Band 1 Level) -15–+15 dB
Specify the gain (amount of boost or cut) at 250 Hz.
BAND 2 (Band 2 Level) -15–+15 dB
Specify the gain (amount of boost or cut) at 500 Hz.
BAND 3 (Band 3 Level) -15–+15 dB
Specify the gain (amount of boost or cut) at 1000 Hz.
L out
Mix
R out
L out
R out
91