5-4. Adjusting the main shaft stop position
If the position of the marker line (blue) on the handwheel is too far from the position of the
marker line (blue) on the cover after thread trimming, machine head angle should be adjusted
following the steps of procedure described below.
A
❻
❼
❶
A
B
– 63 –
1) The function setting screen is displayed
by keeping
three seconds on the normal sewing
state.
❽
2) Press
setting No. A on and off. In this state,
press
ter P72.
3) Turn handwheel ❶ in the normal direc-
tion of rotation to align marker line A
on the electrical box cover with marker
line B on the handwheel.
❽ to determine the set-
4) Press
ting.
to return the sewing
5) Press
machine to the sewing state.
held pressed for
❼ to flash function
❻ to select parame-