Power Switch - JUKI DDL-8000AS Instruction Manual

2-12. Power switch

* The switch configuration differs with the specifications.
Single phase
220 to 240V
3-phase 200 to 240V,
Single phase 100 to 120V
❷
EU-Type model
Single phase 220 to 240V
1) Turning the power ON with the power switch
The power to the sewing machine is placed in the
ON state when the "|" mark side of power switch
❶ (1ø 220 - 240V type) is pressed; or in the OFF
state when the "0" mark side is pressed.
The power to the sewing machine is placed in the
ON state when the ON button of power switch ❷
❶
(3ø 200 - 240V type) is pressed; or in the OFF
state when the OFF button is pressed.
The power to the sewing machine is placed in the
ON state when the knob of power switch ❸ (EU
type, 1ø 220 - 240V type) is turned by 90 degrees
counterclockwise; or in the OFF state when it is
turned clockwise to return to its home position.
❸
– 13 –
1. Do not strongly tap the power switch
by hand.
2. If the power indicator LED on the
panel does not light up after having
turned ON the power switch, immedi-
ately turn OFF the power switch and
check the supply voltage.
When you want to re-turn ON power
switch after carrying out the afore-
mentioned steps, it is necessary to
wait for five minutes or more after
you have turned OFF power switch.
3. Do not place your hand or anything
under the needle since the needle bar
may automatically move according
to the memory switch setting when
you turn ON the power to the sewing
machine.