Adjusting The Main Shaft Stop Position - JUKI DDL-8000A Instruction Manual

5-4. Adjusting the main shaft stop position

If the position of the marker line (blue) on the handwheel is too far from the position of the
marker line (blue) on the cover after thread trimming, machine head angle should be adjusted
following the steps of procedure described below.
A
❻ ❼
❶
A
B
– 59 –
1) The function setting screen is displayed
by keeping

three seconds on the normal sewing
state.
❽
2) Press
setting No. A on and off. In this state,
press
ter P72.
3) Turn handwheel in the normal direction
of rotation to align marker line A on
the electrical box cover with marker
line B on the handwheel.
❽ to determine the set-
4) Press
ting.
 to return the sewing
5) Press
machine to the sewing state.
 held pressed for
❼ to flash function
❻ to select parame-