Installing The Pedal Sensor; Installing The Power Switch (For Ce) - JUKI DDL-900B Instruction Manual

2. Installing the pedal sensor

❶

3. Installing the power switch (for CE)

WARNING :
1. Be sure to attach the ground wire (green/yellow) to the specified location (on the ground side).
2. Take care not to allow terminals to come in contact with each other.
3. When closing the power switch cover, take care not to allow the cord to be caught under it.
❹
❷
1ø 220V-240V
Blue
❷
Green/
Yellow
Brown
❶
Blue
Green/
Yellow
❸
Brown
– 4 –
1) Install the pedal sensor to the table with mounting
screws ❶ supplied with the unit.
It is necessary to install the pedal sensor at such
a position that the connecting rod is perpendicu-
lar to the table.
2) After the completion of installation of the pedal
sensor on the table, place the sewing machine
head on the table.
Do not insert the power plug into the plug
receptacle.
1) Remove screw ❶ on the side face of the power
switch cover to open the power switch cover.
2) Pass AC input cord ❷(40145128),
❸(M6102461DAA) through the rear face of the
power switch. Bundle the cord with cable clip
band ❹ to secure it.
3) Securely fix the terminals of the AC input cord
❷(40145128), ❸(M6102461DAA) by tightening
the screws at the specified locations.
4) Close the power switch cover. Tighten screw ❶
on the side face of the power switch cover.