Appendix B Inova System Integration - Lincoln Electric FineLine 170HD Operator's Manual

BK8053-000111 Rev D

Appendix B Inova System Integration

B.1 Inova System Components
The Inova torch height control system requires the following components to be
added to the FineLine 170HD System:
Inova Positioner
Inova Control Console, 115V
Inova Control Console, 230V
Optional - Inova Remote, Imperial Units
"A" Cable
"B" Cable
"F" Cable
"G" Cable (for use with Burny CNCs)
CNC Interface Cable
* where –XX is the cable length in feet
Unlike other Inova configurations, a separate Voltage Divider Card is not required
when using the FineLine 170HD System.
When the CNC is a Burny controller, the optional G Cable allows the following
parameters to be set through the FineLine User Interface (on the CNC); otherwise,
they must be set through the Inova Remote:
• Cut / Mark Pierce Time
• Cutting / Marking Height
• Pierce / Initial Height
• Arc Voltage
Refer to the Inova System manual for installation and operation instructions that are
not covered in this section.
Inova will not function with DES. If the optional APC is installed as part of the
System, contact Lincoln Electric service department.
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Description
or
or
Inova Remote, Metric Units
Page 127 of 132
FineLine 170HD Plasma System
Part Number Quantity
BK110036
BK110025
or
BK110027
BK110020
or
BK110120
BK711705-XX*
BK711710-XX*
BK711730-XX*
BK711735-XX*
BK602610-XX*
1
1
1
1
1
1
1
1