Lincoln Electric FineLine 170HD Operator's Manual page 68

FineLine 170HD Plasma System
Layout and Navigation
The FineLine UI's main screen – Plasma Setup – is described below. It contains all
selections required to configure the System to cut as well as the corresponding
consumable stack that must be installed into the torch prior to cutting.
Navigation
Tabs – Press
to access the
desired screen.
Status Bar and Icons
The Status Bar displays important information about the System. Press the Status
Bar or Status button (
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Status Select Torch
Button Button – Press to
Expand or choose the Active
collapse the Torch. Refer to
Status Screen. Section 4.4.4.
) to expand the Status Screen.
Page 68 of 132
BK8053-000111 Rev D
Torch Consumable Stack
Part numbers for the selected
configuration (see below) are
automatically updated as the
configuration is changed.
Selected Configuration
Select the Plasma Process,
Material, Thickness, Current
Lock/Unlock, and Current.
Status Bar
Colors, words, and icons
display important information
about the System.
System On/Off
Button – Press to turn
on/off the System. Refer
to Section 4.2 for the full
operational sequence.
Status Bar icons and
messages include:
• Green color means ready.
• Red color means needs
attention.
• Words describing the
System's condition or an
error message.
= Outputting DC
•
voltage/current.