Lincoln Electric FineLine 170HD Operator's Manual page 73

BK8053-000111 Rev D
4.3.4 Configure CNC and Height Control
Press the Parameters tab to see the cut parameters, based on the selected
configuration on the Plasma Setup tab.
Prior to making a cut or mark, confirm that the CNC and Torch Height Control are
configured using the displayed cut parameters.
For reference purposes, cut charts are published in a standalone document,
BK8053-000108 (Cut Charts for LC300M Plasma Torch).
Confirm the desired marking gases are selected. Refer to Section 4.4.3.
When an edge start is recommended in the cut chart, the Edge Start LED will
illuminate green. The torch should be positioned at the edge of the material prior to
starting the arc. When the Edge Start LED is red, the cut can begin with a pierce.
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Edge Start LED illuminates Green
for edge start or Red for pierce.
Page 73 of 132
FineLine 170HD Plasma System