Lincoln Electric FineLine 170HD Operator's Manual page 84

FineLine 170HD Plasma System BK8053-000111 Rev D
Apply lubricant to all o-rings on torch. Thread the retaining cap onto the torch
until it is fully seated.
Apply lubricant to the o-ring on the shield cap. Push the shield cap onto the
retaining cap until it is fully seated.
Thread the outer retaining cap onto the torch until it is fully seated.
If applicable, install the Quick-Disconnect Torch Head.
Apply primary power to the Power Supply.
Swirl Retaining Shield Outer
Torch Electrode Nozzle
Ring Cap Cap Cap
Step
12
Step 11 Step 13 Step 14 Step 15 Step 16
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Page 84 of 132