Lincoln Electric FineLine 170HD Operator's Manual page 74

FineLine 170HD Plasma System
4.3.5 Override Standard Pressures (Optional)
Although not necessary, Plasma and Shield cutting pressures can be changed from
standard cut chart values to accommodate special circumstances or to fine-tune a
cut. This optional override should only be made by experienced operators because
serious damage to equipment may occur.
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Press either the Plasma or Shield
cutting pressure values. Press
delete (
keypad, enter a new value, and
then press Apply.
Plasma cutting pressure more
than ±5 PSI from the standard
cut chart value or permanent
damage to consumables and/or
torch may occur.
Shield cutting pressure can be
changed to any value.
Press the red "chart" icon (
reset both the Plasma and Shield
cutting pressures to standard cut
chart values.
Page 74 of 132
BK8053-000111 Rev D
) or clear ( ) on the
WARNING: Do not change
) to