Removing The Front Bezel; Reinstalling The Front Bezel; Removing The Top Cover - Intel AC450NX Product Manual

B
A

Removing the Front Bezel

The plastic front bezel is attached to the chassis with press-in rivets and spring clips in the same
manner as the peripheral bay cover.
1. Observe the precautions on page 115, "Safety Guidelines."
2. Remove the peripheral bay cover as described earlier.
3. Grasp the bezel hand and pull.
4. Place the bezel on a smooth surface so that it does not get scratched.

Reinstalling the Front Bezel

1. Install the peripheral bay cover as described earlier.
2. Position the front bezel in position and press into place.

Removing the Top Cover

See Figures 12-3 and 12-4.
1. Observe the precautions on page 115, "Safety Guidelines."
2. Turn off all peripheral devices connected to the server.
3. Turn the server off with the push-button on/off power switch on the front panel.
4. Unplug the AC power cord from the power inlet receptacle, or from the power source outlet.
5. Label and disconnect all peripheral cables attached to the I/O panel on the back of the server.
Figure 12-2. Peripheral Bay Cover and Front Bezel
A. Plastic snap-on Peripheral Bay Cover
B. Plastic snap-on Front Bezel
Chapter 12 Server Covers: Removing/Reinstalling
OM07356
121