Replacing The Cd-Rom Drive - Intel AC450NX Product Manual

AC450NX Rack Server System Product Guide

Replacing the CD-ROM Drive

See Figures 14-2, and 14-3.
1. Remove the CD-ROM drive from the protective packaging, and place it on an antistatic
surface.
2. Record the model and serial numbers of the drive in your equipment log.
3. Set any jumpers and switches on the drive according to the manufacturer's instructions.
4. Using two screws of the appropriate size and length (not supplied), attach each plastic slide rail
to the drive.
5. Orient the drive so that the slide rails engage in the bay guide rails and push the drive into the
bay until the slide rails lock in place.
6. Connect the power signal cables to the drive.
7. Reinstall the peripheral bay as described in Chapter 13, "Server Components:
Removing/Reinstalling"
8. This step is optional. Run the SSU or Setup to specify that the CD-ROM drive is the boot
device. For information about running these utilities, see Chapter 5, "System Setup Utility:
When to Run," and Chapter 4, "Setup Utility: When to Run."
170
D
C
Figure 14-3. Snap-in Plastic Slide Rails
A. CD-ROM drive
B. Tab
C. Screw
D. Slide rail
B
A
OM06742