Table of Contents
Advertisement
Adjusting the support struts
9. Relocate the struts to the opposite, long end of the mast (see
Figure 13).
Relocate them to the round hole, not the square hole.
Square hole (do
not use)
T0139103
Figure 13: Relocating struts
10. Position the strut holders over the hole.
11. Install the carriage bolts, flat washers, and nuts.
The support struts can be adjusted in the following ways:
• The struts' lengths can be adjusted.
• The struts can be rotated to adjust the orientation of the lag
screw mounting brackets so they line up with centers. The
mounting brackets can be rotated also.
• The struts revolve forward or back around the axis of the
carriage bolt. They should always be revolved symmetrically;
that is, the same directions and angle from the mast pipe.
Before adjusting the struts, review Figure 10 on page 42 and
Figure 11 on page 43 to determine the installation configuration
and mounting hole pattern. Mark the mounting hole pattern on
the mounting surfaces. Usually, you install the mast foot before
adjusting the arms.
Round hole
Chapter 4 • Installing mounts
1035678-0001 DRAFT Revision 1.04
45
Advertisement
Table of Contents
