Related publications
Tool and fastener sizes
Revision record
• About this document
xiv
1035678-0001 DRAFT Revision 1.04
For antenna assembly instructions, see:
• Assembly Instructions for the .98 m Ku-Band Upgradeable
Antenna (HNS 1035930-0001)
• Assembly Instructions for the 1.2 m Ku-Band Upgradeable
Antenna (HNS 1035931-0001)
This document shows measurements in both United States (U.S.)
and metric (System Internationale, or SI) units of measure.
However, tool and fastener sizes are shown in U.S. units only or
metric units only, depending on the equipment the tool or fastener
is used with. Use the U.S. or metric size tool specified. Tools that
are not an exact fit may damage equipment. Therefore, do not use
tool sizes based on U.S.-metric calculated conversions.
Revision
Date of issue
1.01
August 2, 2004
1.02
September 7, 2004
1.03
October 1, 2004
1.04
October 11, 2004
Scope
First draft release
Second draft release
Third draft release
Post-inspection review