Reassembling The Trimast In Configuration 2 - Hughes DiRECWAY HNS 1035930-0001 Site Preparation Manual

Reassembling the trimast in
T0139102
Chapter 4 • Installing mounts
44
1035678-0001 DRAFT Revision 1.04
To reassemble the trimast in configuration 2:
configuration 2
Notice mast foot orientation
during install
Figure 12: Relocating the mast foot
1. Ensure the roof pitch and configuration calls for mast
configuration 2.
2. Use a 1/2-inch wrench to remove the two nuts and flat
washers holding the support struts to the mast foot.
3. Remove the two carriage bolts.
4. Relocate the mast foot at the opposite, short end of the mast
(see Figure 12).
Orient the foot as shown so that you can push the bolts up
from inside the mast pipe.
5. Align the bolt holes with the square holes on the mast.
6. Reinstall the carriage bolts, flat washers, and nuts.
7. Use a 1.2-inch wrench to remove the nut and flat washer on
the carriage bolt holding the two struts to the mast.
8. Remove the carriage bolt.
Short end