Table of Contents
Advertisement
Chapter 4 • Installing mounts
40
1035678-0001 DRAFT Revision 1.04
The placement of the support struts varies according to the pitch
of the roof and the distance between rafters or trusses (see
Figure 10).
These factors may require you to change the mast configuration if
they exceed certain limits. For details, see Reassembling the
trimast in configuration 2 on page 44.
Table 6 lists the parts required to install the mount on a
wood-framed roof.
Table 7 lists the tools required to install the mount on a
wood-framed roof.
Table 6: Parts required for a wood framed roof installation
Part
Lag screws
Flat washers
Flat washers - large
Silicone sealant
Table 7: Tools required for a wood framed roof installation
Tool
Carpenter's level
Pencil or chalk
Ruler
Socket wrenches
Drill
Drill bits
Torque wrench
Ladder
CAUTION
• For enterprise installations, install the satellite dish
assembly using a non-penetrating mount unless the
customer-specific specification states that one of the
other installation methods documented in this manual
is to be used.
• Roof installations may void the building's roof warranty
so extreme care should be exercised. Contact your HNS
installation management team if you have any
questions.
Type
3/8-inch x 4-inch
3/8-inch
3/8-inch
Type
1/2 and 9/16-inch
3/8-inch electric
3/8-, 1/4-, and 1/8-inch
Torque up to 18 ft-lbs
Quantity
4
4
2
Advertisement
Table of Contents
