Table of Contents
Advertisement
4. Press the IRIS buttons to close or open the lens iris.
Adjust the lens iris by using the buttons to obtain
the proper picture exposure.
I R I S
CLOSE
By pressing both of these buttons at the same time,
the lens iris is reset to the initial factory settings.
2. Pan/Tilt Control (Manual Operation)
1. Select the desired camera referring to the Camera
Selection procedure described on page 42.
2. Press the Direction Arrow buttons to move the
pan/tilt head in the desired direction.
Pressing the UP and RIGHT buttons will move the
pan/tilt head upwards and to the right.
LEFT
HOME/SET
DOWN
Note: To move the pan/tilt head faster, press the
HOME/SET button while holding down the
Direction Arrow Buttons.
3. Pan/Tilt Control (Preset Operation)
The following functions are available only with cam-
eras that have preset panning functions, such as
the Panasonic WV-BS500 or WV-CS600 series.
Note: Select only preset position numbers 1 to 16.
1. Select the desired camera referring to the Camera
Selection procedure described on page 42.
2. Press the PRE-POSI button.
PRE-POSI
3. Press the CAMERA(1 - 16) buttons to select the
preset position number and move the pan/tilt head
to the preset position.
Note: Select a number from 1 through 16. ("17" is
not allowed.)
OPEN
UP
RIGHT
4. Auto Panning
The following function is available only when the
specified Pan/Tilt Head is used.
1. Select the desired camera referring to the Camera
Selection procedure described on page 42.
2. Press the AUTO button to activate the auto panning
function.
3. To cancel the auto panning function, press one of
the Direction Arrow Buttons.
Note: When using AUTO PANNING with combina-
tion cameras, make sure that the LOCAL/
REMOTE selection is set to LOCAL at the cam-
era site. If REMOTE is selected, the panning
movement is retained for only one minute.
5. Home Position Selection
The following functions are available only with cam-
eras that have preset panning functions, such as the
Panasonic WV-BS500 or WV-CS600 series.
1. Select the desired camera referring to the Camera
Selection procedure described on page 42.
2. Press the HOME/SET button to move the camera to
the home position.
6. Camera Setup
1. Select the desired camera referring to the Camera
Selection procedure described on page 42.
2. Press the SETUP/ESC button, while holding down
the selected CAMERA button, to access the
Camera SetUp Menu.
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
LENS DRIVE
END
-43-
UP
LEFT
HOME/SET
RIGHT
DOWN
** CAM SET UP **
OFF
ALC
---
ON
OFF
INT
AWC
ON
DC
SET UP DISABLE
CAMERA/PRESET POSITION
SET UP/ESC
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Advertisement
Table of Contents
