Table of Contents
Advertisement
INSTALLATIONS
The installations described below should be made
by qualified service personnel or system installers.
Installing the WV-PB6164 Data Multiplex
Boards
When controlling the camera with the multiplexed
control data by connecting a coaxial cable, the WV-
PB6164 Data Multiplex Board must be installed in
the Video Multiplexer.
Four data multiplex boards are included with the
WJ-FS616 for cameras 1 to 4.
Please note that additional multiplex boards are
available for purchase as model WV-PB6164 Data
Multiplex Boards, which includes four control
boards.
Caution: Before installing boards, be sure to turn
off the Power Switch of the video multiplexer.
1. Remove the six screws on the top cover of the
video multiplexer as shown below.
Rear
2. Remove the top cover.
3. Remove the four screws on the board as shown
below.
4. Remove the one screw shown below. Then turn
over the printed circuit board with the front side up.
5. Pull out the two knobs from the bracket shown
below. Then remove the bracket.
Front
-10-
Advertisement
Table of Contents
