Table of Contents
Advertisement
ENTRANCE
STILL
Note: You can stilled multiple pictures on the multi-
screen.
5. Press the blinking CAMERA button to cancel the
Still function.
6. Press the STILL button again. The displayed pic-
tures returns to normal viewing.
The LED on the STILL button goes off.
6. Spot or Multi Sequence
1. Press the MULTISCREEN button. The LED (green)
on the button lights up.
2. Press the SEQUENCE button to activate the
sequence (SEQ1, SEQ2 or SEQ3) programmed.
The LED on the SEQUENCE button lights up.
Note: Refer to the Sequence Setup on page 31 for
more details.
SEQ1:
Spot Sequence
SEQ2:
Multi Sequence
SEQ3:
Multi Sequence
3. Press the SEQUENCE button to move one step for-
ward in the sequence.
4. To cancel the sequence, press one of the following
buttons:
CAMERA: Displays the selected camera picture in
Single Spot mode.
MULTISCREEN SELECT:
Displays a Multi Spot picture.
Displaying the Playback Picture
The following procedures are not applicable to
the Multiscreen 2 Monitor.
1. Press the MULTISCREEN button. The LED (green)
in the button lights up.
2. Press the VCR/CAM button to VCR position (LED
on).
Notes:
• This unit does not reproduce a clear picture in
reverse playback.
• The playback picture may be skewed (horizon-
tally distorted) in the upper portion of the moni-
tor screen depending on the selected playback
mode.
• The LED on the VCR/CAM button blinks when
no signal is input to the PLAY IN connector. The
LED also blinks if the codes (camera numbers,
etc.) recorded on the VCR tape track have not
been read for some reason. In this case, the
playback picture is displayed simply by tracing
along the tape. Skipping instructions or other
selections are ignored.
• The looped through VCR output may appear on
the monitor while playing back a tape in forward
or reverse search.
• The picture or title may become unstable
because of the recording field rate.
• Depending on the condition of the VCR's video
heads, the pictures of another channel may
appear on the monitor.
If this occurs frequently, adjust the tracking
and slow tracking of the VCR.
• The size of pictures displayed on the multi-
screen is smaller than in single picture format,
which makes the titles hard to read. Select sin-
gle picture (spot) to make titles easier to read.
• Playback in linear mode (L12H, L18H, L24H)
may produce noise or the picture of another
channel in any recorded mode. Play back the
tape in normal (real time mode) or time lapse
mode.
• Select FS10 in the SETUP MENU to play back a
tape recorded with the WJ-FS10. (See page 35)
It is recommended to play back on the 16-seg-
ment screen and select the desired camera
channel from the pictures displayed, because a
tape recorded with the WJ-FS10 Multiplexer is
not compatible with one recorded on the WJ-
FS616 (the camera display channels for record-
ing and playback differ).
-40-
MULTI
SCREEN
VCR
CAM
Advertisement
Table of Contents
