Panasonic WJ-FS616C Operating Instructions Manual page 8

49. Record Output Connector (REC OUT, VIDEO /
S-VIDEO)
The recording signal for the time lapse VCR is pro-
vided via this connector.
This connector can also be used as multiscreen out-
put 2 with the specified conditions.
50. Playback Input Connector (PLAY IN, VIDEO /
S-VIDEO)
The playback signal from the time lapse VCR is sup-
plied to this connector.
51. Multiscreen Output Connector (MULTISCREEN
OUT)
The video output signal for the multiscreen monitor
is provided via this connector
52. RS-232C Port (VCR CONTROL, RS-232C)
The VCR control signal for the time lapse VCR is
provided via this connector.
Connecting a PC to this connector will allow you to
remote control the video multiplexer.
53. Remote Output Connector (VCR CONTROL,
REMOTE OUT)
The VCR control signal for the time lapse VCR is
provided via this connector.
You can select on the setup menu whether to have
the VCR control signal supplied from this connector
or the RS-232C Port.
54. Alarm / Remote Control Connector (ALARM /
REMOTE)
This connector accepts the alarm signals from the
associated alarm sensor units and the control sig-
nals from the external system.
55. Power Cord
56. Signal Ground Terminal (SIGNAL GND)
57. Termination Switch (TERM., OFF / ON)
This switch is used to enable termination of the
video multiplexer's data port.
58. Data Port (DATA, OUT / IN)
These ports are used to exchange control data with
the WV-CU550A System Controller or a PC in a sys-
tem.
-6-