Table of Contents
Advertisement
3. Electronic Zooming
1. Repeat the procedures described above for Single
Spot.
2. Press the EL-ZOOM button to display the zoomed
picture.
The LED on the EL-ZOOM button lights up.
EL-ZOOM
3. Press the UP, DOWN, LEFT or RIGHT button to
move the picture in the desired direction.
Note: Operating these buttons beyond the picture
range activates control of the pan/tilt head.
4. To cancel this mode, press the EL-ZOOM button
again.
The selected camera picture is displayed in spot
mode, and the LED on the EL-ZOOM button goes
off.
4. Multi Spot
1. Repeat steps 1 and 2 described for Single Spot on
page 38.
2. Press the MULTISCREEN SELECT button repeat-
edly.
MULTISCREEN
SELECT
Each time the MULTISCREEN SELECT button is
pressed, the next of the 6 available multiscreens is
displayed as follows.
ENTRANCE
ENTRANCE
1
2
3
4
4 SEGMENT SCREEN
1
2
4
5
7
8
9 SEGMENT SCREEN
2
1
4
6
7
8
10
11
12
13 SEGMENT SCREEN
Notes:
• Blank channels are displayed in black.
• Dividing patterns and segment numbers are
shown above.
• Any camera can be assigned to any segment in
a pattern.
5. Multi Still
1. Repeat steps 1 and 2 described for Single Spot on
page 38.
2. Press the MULTISCREEN SELECT button repeat-
edly to display the desired multiscreen.
The divided screens appear on the monitor screen.
3. Press the STILL button. The LED on the button
lights up.
4. Press the CAMERA button corresponding to the
picture you want to be stilled.
The LED on the pressed CAMERA button starts to
blink.
-39-
1
4
3
6
7 SEGMENT SCREEN
3
1
6
3
4
5
9
7
8
9
10 SEGMENT SCREEN
3
1
2
3
5
5
6
7
9
9
10
11
13
13
14
15
16 SEGMENT SCREEN
2
5
7
2
6
10
4
8
12
16
Advertisement
Table of Contents
