Panasonic WJ-FS616C Operating Instructions Manual page 15

WV-CU550A System Controller
Modifying the Front Panel
1. Peel the tape off the supplied panel templates, then
attach them on the front panel of the System
Controller.
2. Peel off the label and attach it on the rear of the
System Controller as shown below.
ON
DATA CONTROLLER
IN OUT UNIT NO. MODE
1-8
TERM
0
ON OFF
Connection with
Video Multiplexer
(WJ-FS616)
0
TERM. MODE
OFF
OFF
ON
CONTROLLER
ON OFF
WJ-FS616 Video Multiplexer
Mounting in the Rack
1. Remove the four rubber feet by removing the four
screws on the bottom of the video multiplexer.
Remove 4 rubber feet
2. Place the rack mounting brackets on both sides of
the video multiplexer and tighten with the four sup-
plied screws (M4 X10).
3. Install the video multiplexer with the rack mounting
brackets in the rack by using four screws (not
included).
Cautions:
• Do not block the ventilation opening or slots on
the cover to prevent the appliance from over-
heating.
Always keep the temperature in the rack within
45°C (113°F).
• Secure the rear of the appliance to the rack by
using additional mounting brackets (procured
locally) if the rack is subject to vibrations.
-13-