Table of Contents
Advertisement
Connections
In this type of installation, only one Video Multiplex-
er is connected directly to the System Controller by
a control cable.
The rest of the Video Multiplexers are connected to
the system Controller in a daisy-chain type connec-
tion.
Refer to the connections and data port settings
shown below.
Local Site
Main Site
Video Multiplexer
Video Multiplexer
WJ-FS616
SPOT
SPOT
OUT
I N
OUT
DATA
OUT
IN
TEAM.
OFF
ON
Notes:
• Up to four Video Multiplexers can be daisy-
chained to the System Controller.
• Unit numbers should be assigned in the order
of connection, starting with the unit connected
directly to the WV-CU550A System Controller.
• Sequence display is limited to the cameras con-
nected to one multiplexer unit only.
• It is recommended to set the LOCK switch to
the ON position while making these connec-
tions.
• For controlling more than 4 cameras, additional
WV-BP6164 Data Multiplex Boards need to be
installed in the Video Multiplexer.
Operating Procedures
1. Confirm that the camera and peripherals are con-
nected correctly and firmly.
2. Turn on the power switches of all system compo-
nents.
3. Confirm that the DAISY MODE parameter on the
SYSTEM SETUP menu is set to ON.
4. Select the unit number of the Video Multiplexer with
the Numeric Keys. Then press the UNIT/ESC key to
activate the selected unit.
1
2
4
5
7
8
0
MON
UNIT/ESC
WJ-FS616
I N
DATA
CONTROLLER
DATA
OUT
IN
IN
OUT
TEAM.
TERM
OFF
ON
ON
OFF
3
6
9
CAM
SET
For example, press the keys shown below.
2
In this example, the picture of Camera No. 15 con-
nected to Video Multiplexer Unit 2 is displayed on
the Spot Monitor connected to Video Multiplexer
Unit 1.
5. Operate the selected unit as described in the
OPERATING PROCEDURES.
6. Select another unit with the Numeric Keys. Then
press the UNIT/ESC key to activate the selected
unit.
UNIT NO.
1-8
0
Other Applications
• Application 1
The video signal looped through the SPOT IN con-
nector can be displayed on the Spot Monitor.
VIDEO
Unit
1. Confirm that the DAISY MODE on the SYSTEM
SETUP menu is set to OFF.
2. Select the unit number of the Video Multiplexer with
the Numeric Keys. Then press the UNIT/ESC key to
activate the selected unit.
3. Press the (F2) button on the controller to select the
spot monitor.
4. Press [ 0 ] then press the SET key to display the
video on the Spot Monitor looped through the SPOT
IN connector.
-53-
1
5
MON
UNIT/ESC
VIDEO
2
Unit
1
CAM
SET
Advertisement
Table of Contents
