Table of Contents
Advertisement
CAMERA CONTROL
FUNCTION
Camera control is only available while the camera
picture is displayed in Single Spot on the monitor
screen.
Note: When controlling the camera with multiplexed
control data by connecting a coaxial cable, you
should
install
the
Multiplex Board in the Video Multiplexer.
Camera Selection
1. Set the LCD display to
edly pressing the F2 or F1 button on the controller.
2. Select the camera (VCR) by pressing the Function
(F4) button on the controller.
3. Select the desired camera by pressing the numeric
keys, then press the SET key.
The selected camera picture is displayed in Single
Spot on the selected monitor screen.
Controlling System Accessories
1. Lens Control
1. Select the desired camera referring to the Camera
Selection above.
2. Press the FOCUS button to adjust the lens focus to
obtain a sharply focused picture while observing the
monitor.
If you are using the specified camera with auto
focus feature, you can adjust the lens focus auto-
matically by pressing the AF button.
FOCUS
NEAR
FAR
3. Press the ZOOM button to adjust the lens zoom to
obtain the desired picture while observing the moni-
tor.
Press this button to the TELE position to optically
bring an object closer. Pressing to the WIDE posi-
tion has the reverse effect.
ZOOM
optional
WV-PB6164
Data
SPOT or
MLT by repeat-
AF
TELE
WIDE
4. Press the IRIS buttons to close or open the lens iris.
Adjust the lens iris by using the buttons to obtain
the proper picture exposure.
By pressing both of these buttons at the same time,
the lens iris is set to the initial factory settings.
2. Pan/Tilt Control (Manual Operation)
1. Select the desired camera referring to the Camera
Selection above.
2. Move the joystick to move the pan/tilt head in the
desired direction.
If the joystick is positioned in between UP and
RIGHT, the pan/tilt head moves diagonally upwards
and to the right.
The moving speed of the PAN /TILT head depends
on the tilt of the joystick. The more you tilt it, the
faster the head moves on the combination cameras.
3. Pan/Tilt Control (Preset Operation)
The following functions are only available with cam-
eras that have preset panning functions, such as
the Panasonic WV-BS500 or WV-CS600 series.
1. Select the desired camera referring to the Camera
Selection above.
2. Press the PRE-POSI button, then select the preset
number by pressing the numeric keys.
PRE-
POSI
3. Press the SET key to move the pan/tilt head to the
preset position.
4. Auto Panning
The following function is only available when the
specified Pan/Tilt Head is used.
1. Select the desired camera referring to the Camera
Selection above.
2. Press the AUTO button to activate the auto panning
function.
-50-
IRIS
CLOSEOPEN
1
2
3
4
5
6
7
8
9
0
MON
CAM
UNIT/ESC
SET
AUTO/+
AUX2
Advertisement
Table of Contents
