Alarm Control Function - Panasonic WJ-FS616C Operating Instructions Manual

Video multiplexer

Hide thumbs Also See for WJ-FS616C:

Operating instructions manual (82 pages)

Table Of Contents

Table of Contents

Enlarged version

3. To cancel the auto panning function, move the joy-

stick controller in the desired direction.

Note: When using AUTO PANNING with combina-

tion cameras, make sure that the LOCAL/

REMOTE selection is set to LOCAL at the cam-

era site. If REMOTE is selected, the panning

movement is retained for only one minute.

5. Home Position Selection

The following functions are only available with cam-

eras that have preset panning functions, such as the

Panasonic WV-BS500 or WV-CS600 series.

1. Select the desired camera referring to Camera

Selection on page 50.

2. Press the HOME button to move the camera to the

home position.

HOME/–

6. Camera Setup

1. Select the desired camera referring to Camera

Selection on page 50.

2. Press the CAMERA SET ON button to access the

Camera Setup Menu.

The display on the LCD changes as shown below.

SET UP

CAMERA

SET ON

REV

T/L MODE

U01 C01 CamSet Up

3. Select an item by moving the joystick UP or DOWN.

Then select the mode by moving the joystick LEFT

or RIGHT.

4. Press the SET key to execute the setting or enter a

sub menu.

5. To return to the previous menu, press the UNIT key.

6. Press the F3 button to reset the selected function,

or press F4 to reset all functions to the initial state.

7. Press the CAMERA SET OFF button to escape

from the setup mode or menu.

Note: Refer to the operating instructions for select-

ed camera for more details.

Caution: Camera addresses are important for RS-

485 type cameras.

1. Do not use addresses other than 1 through 16

for individual cameras. ("17" is not allowed.)

2. Do not set the same address for more than one

camera in an RS-485 chain.

AUX1

CAMERA

SET OFF

PLAY

RES A.RES

• Simplified preset position setting

The preset position can be set by a simplified pro-

cedure.

The following functions are only available with cam-

eras that have preset panning functions, such as

the panasonic WV-BS500 or WV-CS600 series.

1. Press the ALT button while the position setting

menu is displayed.

2. Move the joystick controller to move the pan/tilt

head in the desired direction.

3. Move the FOCUS or ZOOM button to adjust the

lens to obtain the desired picture.

4. Press the ALT button again to restore the joy-

stick controller's cursor control function.

Caution: If the camera setup is started with the but-

tons on the camera, all future settings must also

be made with these buttons.

If the camera setup is started from a controller,

all future settings must also be made from the

controller.

7. Auxiliary Control

The following function is available only with a sys-

tem

that

includes

Receivers.

1. Select the desired camera. Refer to the Camera

Selection on page 50.

2. While the ALT switch is on, press the AUX1 or

AUX2 button to enable or disable the user's auxil-

iary switch in the Receiver.

ALT

Note: The auxiliary control is not available while

operating the zoom or pan/tilt head.