Table of Contents
Advertisement
16. Function Button (FUNCTION)
This button is used to display the VCR playback
picture with the camera pictures on the multiscreen
monitor.
During the setup, this button is used to select the
next page.
17. Auto/Increment Button (AUTO / + )
This button is used to activate the auto panning
function.
During the setup, this button is used to select the
desired parameter in the setup menu.
18. Home/Decrement Button (HOME / – )
This button is used to move the camera to the home
position.
During the setup, this button is used to select the
desired parameter in the setup menu.
19. Alternate Button (ALT)
Press this button to have the other 8 buttons switch
to their alternate functions. These buttons are iden-
tified by special labeling - - text or a symbol in a
rounded corner rectangular. For example, while the
indicator (green) of the ALT button is lit, pressing
the STILL button controls the VCR rewind function.
20. Multi Screen Selection Button
(MULTISCREEN SELECT)
This button is used to select the desired multi-
screen to be displayed on the multiscreen monitor,
when monitoring the camera picture or VCR play-
back picture.
Pressing this button repeatedly will switch the
screen as follows:
Camera Picture:
4 7 9 10 13 16 4 screen segments
VCR Playback Picture:
4 9 16 4 screen segments
21. Electronic Zoom Button (EL-ZOOM)
This button is used to zoom the picture currently
displayed on the monitor screen.
Note: The above operation is not valid unless multi-
screen output is selected by pressing the (F1)
Function button.
22. Alarm Reset Button (RESET)
This button is used to cancel an active alarm of the
currently selected unit and to return to the condition
before the alarm function was activated. When plur-
al Multiplexer units are connected in a daisy chain,
pressing the ALT button and then this button resets
all alarm inputs at once.
23. Data Ports (DATA, IN / OUT)
These ports are used to exchange control data with
the WJ-FS616 Video Multiplexer.
24. Termination Switch (TERM., ON / OFF)
This switch is used to enable termination of the con-
troller's data port.
When combined with the WJ-FS616 Video Multi-
plexer, set this switch to the "ON" position.
25. Controller Unit Number Switch
(CONTROLLER UNIT NO. 1-8)
This switch is used to identify the unit number of the
System Controller.
When combined with the WJ-FS616 Video Multi-
plexer, set this switch to the "0" position.
26. Mode Selection Switches (MODE)
These switches are used to select the mode of the
system controller connected to the video multiplex-
er.
When combined with the WJ-FS616 Video Multi-
plexer, set as shown below.
OFF
ON
27. Controller On / Off Switch
(CONTROLLER ON / OFF)
This switch is used to turn the power of the system
controller on or off.
28. Power Cord
-9-
MODE
Advertisement
Table of Contents
