Specifying Snmp Properties - Nortel 2340 Configuration Manual

Specifying SNMP properties

Using the System Settings Page, Notifications Tab to Specify SNMP Trap Properties as shown below.
SNMP1 and SNMP2
• Destination Host: The IP address of the machine which can receive the trap.
• Destination Port (default is 162): The default can be accepted.
• SNMP Version: Select the version in use, either v2c or v3.
• SNMP Community (specify only if using SNMP Version 2c): Specify the same community name here as on the
destination host.
SNMP Version 3
• Use Authentication: Check to guarantee that the trap is coming from the Nortel WLAN Location Engine (to thwart
spoofing).
• Use Privacy/Encryption (Requires Authentication): Check to guarantee that the trap cannot be intercepted.
• Authentication Protocol: Specify the same protocol as on the destination host.
• Username: Any valid username on the destination host.
• Authentication Pass phrase: Set only if Use Authentication is checked.
• Privacy Pass phrase (Defaults to Authentication Pass phrase): Specify a secure password only if Use Privacy/
Encryption is checked.
• Context Engine ID: Any ID except one for another originator of traps.
• Context Name: Not currently used.
Nortel WLAN Location Engine 2340 Web GUI 49
Nortel WLAN - Location Engine 2340 Configuration - Using Interfaces