Nortel 2340 Configuration Manual page 35

Using the Calibration RF Fingerprints Page
After entering the admin user name and password established at installation, repeat the following procedure for each RF
fingerprint to capture the RF fingerprint data:
1
Select the Calibration>RF Fingerprints. The following window appears.
2
If the RF fingerprint to be captured was previously created, select it from the left panel. It was not
previously done, then click Add. The default name New RF Fingerprint appears in both columns, and
calibration controls are added to the RF Fingerprint Information column.
3
In the RF Fingerprint Information column, replace the default name New RF Fingerprint with a name
that describes the location of the RF fingerprint, for example mailroom-nw.
4
Select the correct Locale from the Bound to Locale drop down list. An RF fingerprint can be bound to
only one locale.
5
Enter the MAC Address of the wireless device being used to calibrate, as hex pairs separated by a colon
(:).
6
Click Start. The message 'Buffering...' displays, after which a flashing Progress label indicates the
percent complete, and a graph shows the signal strength for the RF fingerprint as seen by each Location
AP.
Note.
address is entered.
If the buffering continues for more than 60 seconds, make sure the correct MAC
Nortel WLAN - Location Engine 2340 Configuration - Using Interfaces
Nortel WLAN Location Engine 2340 Web GUI 35