Editing, Adding, And Removing Location Ap - Nortel 2340 Configuration Manual

Location AP list will show names (or IP address if the Location AP has not yet been given a name) and a status color as
shown below.
Green: The Location AP is responding frequently to server requests. If the number of devices seen by a Location AP
seems low (the number inside the green box), check the Location APs antenna connection.
Yellow: The Location AP has not responded for 10 seconds, indicating intermittent network coverage.
Red: The Location AP is not visible to the server, due to a network problem or malfunctioning or unplugged Location
AP.
After correcting a malfunctioning Location AP, refresh the page to verify that the status is green. If not, check with the
network administrator to verify that the network port is live. You can also use the Refresh Location AP Status at the
bottom of the page to get periodic updates of Location AP status.

Editing, adding, and removing Location AP

You can edit, add, and remove the location AP. To do this, follow the below procedures.
To edit an Location AP
1
Click on Location AP from the Location AP list.
2
The right hand pane will display a Name, Description and IP Address as shown below.
Edit the information and click Save.
3
You can assign a name, that indicates shorthand information about the Location APs location (such as
'3rd Floor NE 1'). The description filed can be used to add even more detailed information, such as
Above Accounts Payable desks.
Nortel WLAN Location Engine 2340 Web GUI 27
Nortel WLAN - Location Engine 2340 Configuration - Using Interfaces