Assigning A Static Ip Address To Instant Internet Using A Bootp Or Dhcp Server; Table 3 Mac Address Translation - Nortel BayStack 100-S Install Manual

Assigning a static IP address to Instant Internet using a
BootP or DHCP server
You must configure your BootP or DHCP server to identify the Instant Internet
unit by its MAC address so that you can assign an IP address to Instant Internet.
Following is the general procedures to follow when assigning a permanent IP
address to Instant Internet. For detailed instructions, refer to your system's
documentation.
To assign a static IP address to Instant Internet using an existing BootP or DHCP
server:
1
Determine the Instant Internet unit's serial number.
The serial number is on a sticker on the back of the unit.
2
Translate this number to the unit's MAC address according to the information
in Table 3.

Table 3 MAC address translation

Instant Internet serial number
I01xxxxxx
I0200xxxx
I0300xxxx
I4xxxxxxxxxxxx
I5xxxxxxxxxxxx
For example, the serial number I02001234 has the MAC address of
00:00:81:F2:12:34; the serial number I500E07BF224BB has the MAC
address of 00:E0:7B:F2:24:BB.
3
From your BootP or DHCP server's range of IP addresses, choose an
IP address for your new Instant Internet unit.
This IP address is the static IP address for the Instant Internet unit.
4
Map the selected IP address to the Instant Internet's MAC address on the
DHCP server.
Installing the BayStack Instant Internet Management Software Version 7.11
Appendix A Network support
MAC address
00:C0:11:xx:xx:xx
00:00:81:F2:xx:xx
00:00:81:F3:xx:xx
xx:xx:xx:xx:xx:xx
xx:xx:xx:xx:xx:xx
77