Nortel BayStack 100-S Install Manual page 35

• If the Registration Information dialog box opens, the Install program has
determined that your network environment is either running IPX or is
running TCP/IP and you are using dynamic addressing. Skip to step 8.
5
In the Enter Unit's IP Address dialog box, complete the LAN-side static IP
address for the Instant Internet unit and then click OK.
The Install program selects a partial IP address that is available on your
subnet. If you change this IP address, be sure to select one that is on your
subnet.
A DHCP server confirmation dialog box, titled Instant Internet Setup, opens.
6
Select one of the following options:
• Click Yes to have the Instant Internet unit assign a dynamic IP address to
each workstation.
• Click No to be able to assign static IP addresses for each workstation on
your network, including the Instant Internet unit.
The Registration Information dialog box opens
For more information about how Instant Internet functions as a DHCP
server, refer to Using the BayStack Instant Internet Management Software
Version 7.11.
7
In the Enter IP Information for interface dialog box, do the following:
a
Confirm the IP address that is displayed.
b Click the Subnet Mask box to display and confirm the subnet mask.
c
Click OK.
The Registration Information dialog box opens
Installing the BayStack Instant Internet Management Software Version 7.11
Chapter 3 Installing the Instant Internet software 35
(Figure 4). Skip to Step 8.
(Figure 4).