Nortel BayStack 100-S Install Manual page 41

• User ID – Type the user ID you use to connect to the Internet.
• Password – Type the password you use to connect to the Internet.
3 Type the inactivity timeout (in minutes) or use the default of 10 minutes.
The inactivity timeout saves connect-time charges during times when no one
is requesting Internet access. It specifies the number of minutes of inactivity
over the dial-up connection after which Instant Internet terminates the
connection. When you need access again, the Instant Internet unit
automatically reestablishes a connection in a few seconds.
If you enter a value of 0, the inactivity timer is disabled and the Instant
Internet unit maintains the connection regardless of whether or not there is
Internet activity. However, if the line becomes unavailable for any reason
other than inactivity, a connection must be reestablished.
You can also set the inactivity timeout in seconds rather than minutes. For
details, refer to Using the BayStack Instant Internet Management Software
Version 7.11.
4
Click OK.
5
The next steps vary depending on your individual configuration. Select the
option that matches your configuration:
• If you are using the ISDN version, the Enter ISDN Information dialog
box opens (Figure
• If you are installing the dial-up version, skip to step 10.
Installing the BayStack Instant Internet Management Software Version 7.11
Chapter 3 Installing the Instant Internet software 41
6). Proceed with step 6.