Preparing A Network With No Tcp/Ip And No Bootp Or Dhcp Server - Nortel BayStack 100-S Install Manual

Workstations can be forced to renew their IP address leases, however, you must
renew the lease at each workstation. For details see
new information from the Instant Internet unit or your existing DHCP server" on
page 88. For more information about IP address leases, refer to "Scopes and
leases" in Using the BayStack Instant Internet Management Software Version
7.11.
Preparing a network with no TCP/IP and no BootP or DHCP
server
Use this preparation procedure if you have a Windows environment, no
workstation has TCP/IP enabled, and no existing BootP or DHCP server is
installed on your network.
To prepare a network with no TCP/IP and no BootP or DHCP server:
• You must install TCP/IP on each workstation (including the workstation you
used to configure the Instant Internet unit) and set each workstation to obtain
an IP address automatically by selecting the option Use DHCP or Obtain an
IP address automatically (depending on your operating system). For more
information, refer to
"Setting a workstation to get its IP address from Instant Internet or your
existing DHCP server" on page
After you run the Install program and configure the Instant Internet unit as a
DHCP server, Instant Internet assigns an IP address to itself and to the
workstations that are set up to use it as a DHCP server.
Installing the BayStack Instant Internet Management Software Version 7.11
"Installing TCP/IP on a workstation" on page 84
87.
Appendix A Network support
"Setting a workstation to get
81
and