Nortel BayStack 100-S Install Manual page 47

9
Complete the T1 or E1 information as directed by your T1 or E1 service
provider.
Your T1 or E1 service provider and your ISP (if they are not the same) should
provide the T1 or E1 information for this dialog box. The defaults should
work for most installations; however, the line build-out will vary and is
determined by the distance from the Instant Internet unit to the nearest T1 or
E1 repeater.
Note: These configuration settings must match the settings provided by
your T1 or E1 service provider and ISP.
10 Click OK.
11 Do one of the following:
• If your unit has dial backup capability (available on 400-S units), an
Instant Internet Setup dialog box opens prompting you to select whether
or not you want to configure a backup interface. Proceed with step 12.
• If your unit does not have dial backup capability, continue with the
procedure "Finishing the connection configuration" on page
12 Do one of the following:
• If you do not want to configure a backup interface, click No. Continue
with the procedure
• If you want to configure a backup interface, click Yes. The Enter Internet
Service Provider Information dialog box opens
Proceed with step 13.
13 Complete the following information about your backup connection to the
Internet:
• Provider – Select your Internet service provider (ISP) from the list. If you
do not see your ISP in the list, select
Installing the BayStack Instant Internet Management Software Version 7.11
Chapter 3 Installing the Instant Internet software 47
"Finishing the connection configuration" on page
! Default
57.
(Figure 5 on page 40).
.
57.