Installing The Instant Internet Workstation Software From The Network - Nortel BayStack 100-S Install Manual

Installing the Instant Internet workstation software from the
network
To install the Instant Internet workstation software from the network:
1
Choose Start > Run.
The Run dialog box opens.
2
Click Browse to locate the install.exe file and then click OK.
3
If the workstation has both IP and IPX installed on it, a dialog box opens
prompting you to select the type of installation you want to perform. Click the
type of installation and then click OK. Otherwise, proceed with step 4.
The Instant Internet Install dialog box opens prompting you for a private
(local) or network installation.
4
Click Network.
Note: This prompt for a private or network copy of the software is also
where you determine if the administration utilities (next prompt) are
installed. Nortel Networks recommends that you select Network so that
software updates are easily available to all users.
Depending on the information you set in the Workstation Preconfiguration file
(if you are installing the software from the network and if you configured the
file), the Select Components to Install dialog box may open
prompting you to install the administration utilities (Setup, Admin, Monitor,
Tools, and AutoLog). For details on the workstation preconfiguration file,
refer to "Automatically configuring workstations during installation" on
page 60.
Installing the BayStack Instant Internet Management Software Version 7.11
Chapter 3 Installing the Instant Internet software 63
(Figure 18)