Corrections To Quick2Config Annex Release 3.1; Spr 10518 - Bay Networks 5399 Release Note

Remote Access Software Version 5.3 Release Notes
300115-B Rev. A
84
• You should ignore the following erroneous error message:
MSVCR_T40.dll can not be found
• PRI in and out statistics show no activity even though PRI
has been in use.
• Clicking on the http://www.baynetworks.com URL in the
World Wide Web help page brings up an error message.
• In the Basic Dial Access tab, if an inappropriate or out of
range value is applied, a MIB error appears on the screen
instead of an appropriate error message.
• If there is a device in the list that has become unreachable,
selecting it can cause Quick2Config to crash occasionally.
This happens rarely and randomly, and only if the device is
unreachable and is in an unknown state.
• In the WAN interface tab, switch types are not dimmed by
module type. For example, even though the WAN is running
a channelized T1 protocol, the E1 switch types (Korea,
China, Brazil, etc.) are still available. If you select an E1
switch type for a T1 module (or vice-versa), the unit may
enter an erroneous state.
• The following screens are not available for RACs in this
release:
• WAN Internal Modems
• PRI channels
• PRI Internal CSU
• T1 Internal CSU
• T1 Modem Calls
Corrections to Quick2Config Annex Release 3.1

SPR 10518

Quick2Config Annex no longer crashes when there are multiple units in
the list and you select the WAN tab.