Bay Networks 5399 Release Note page 87

• When a voice call is placed to a RAC (PRI) and no modems
are available, the caller will get a ring-no-answer signal
rather than a busy signal.
• If you are using a BitSurfer PRO, the BitSurfer Configuration
Manager software does not set all the parameters necessary to
make async PPP or MP connections. They must be set
manually to the following:
AT&F&C1&D2\Q3%A2=95@M2=P@B0=1%A4=0
(put this in the setup string in your dialer).
Change B0=1 to B0=2 for 2-channel MP.
• In Release 14.1, TMS is not backward-compatible with the
Release 14.0 database. You must run the convert utility in
order to make the database compatible.
• Security does not work on the VCI type CLI.
• The UNIX installation script currently recognizes and installs
software on many platforms other than those that are
officially supported by this release. Please see the section
Supported RAC Hardware For Release 5.3
officially supported platforms.
• In some instances, AFD does not update the Microcom
modem firmware properly. If this happens, use admin to
issue the modem all command, then the set modem
busy_out n command, and reboot the unit.
• When using the cli option from the Console monitor prompt
to start a CLI session, always close the session (hang-up) and
return to the Console monitor before rebooting or resetting
the 5399 RAC. Otherwise, it is possible to get the RAC
Console monitor into an inaccessible state, which will then
require the unit to be physically removed/reinserted in the
5000 hub. This is especially likely if the Hub Supervisory
Reset module command is executed when a CLI session is
left open from the Console monitor.
Remote Access Software Version 5.3 Release Notes
300115-B Rev. A
for the list of
77