Changes to Quick2Config Annex Release 3.1
•
Annex Manager will crash occasionally if you try to go into
Setup mode when running SunOS 2.5.1.
•
On AIX UNIX platforms, in the Setup>Security screen, the
Security/Incoming On/Off buttons are misaligned with the
text fields. This may be due to fonts not being installed on the
system.
•
Customize mode is not supported for this release.
System Requirements
•
Hardware/software requirements - 80486 100MHz
recommended
•
Monitor - VGA or SVGA
•
RAM - 8MB minimum;16MB recommended for
Windows 95; 32MB recommended for Windows NT
•
Free space on hard drive - 6MB for Windows 95 and
Windows NT
•
Mouse - Microsoft compatible
•
Communications stack - compatible with the standard
TCP/IP stacks included with Windows NT and Windows 95
Known Problems/Limitations
The following items are problems and limitations of Quick2Config Annex
Release 3.1:
•
If you select a T1-supporting unit (RA 6100, RA 5391, 5399
RAC, or 8000 RAC) in the tree, then select the WAN
Interface tab, you should ignore the resulting error message:
<annex name> 1.3.6.1.4.1.15.2.11.2.1.15.2 Error:MIB
Variable doesn't exist
Remote Access Software Version 5.3 Release Notes
300115-B Rev. A
83